This white tray table, is 17” diameter round, & is made with genuine tourmaline, smoky quartz crystals, brass and aluminum. 

Premium Countertop epoxy resin was used, so this resin tray is heat resistant Up to to 500F. 

——-

Orgonite tray table ( like coaster charging plate ), can be dual purpose devices.  The Orgonite  charging plate operates the same as any orgonite TB puck device, aimed at balancing energy fields, which  assists with mitigating & protecting against emf radiation (within range of the device).

However, the same Orgonite matrix made into a charger tray shape, can then also be used as a charger base, that folks use to restructure & energize water.  These are also often used to energize & clean gemstones & crystals. Some folks also use these devices to energize essential oils, food, vegetables, fruits, crystal jewelry …. anything you set on top of it.  In general allow 5-30 minutes (volume dependant). 

Living or revitalized/restructured water, has the capabilities that drinking water once had in its natural form, but nowadays, the sources of living water are not readily found anymore, or because of environmental pollution, the water itself may be very unstructured or polluted. Fortunately, tap water is potable in our country, but as it flows through pipes and under pressure, it reduces its vital energy potential. Of course, the substances they add to the water to make it drinkable, does not increase its quality. While such water can be purified to some extent by filtration or a table distiller, it is likely still dead water.

Many people believe structured water can help lead to increased energy, better digestion, enhanced nutrient absorption, and improved hydration. 

Note:  absolutely no medical claims or advice are made or offered here. Always seeks medical advise from your doctor. 

———

 Every single piece is unique, as I make all my orgonite devices by hand, with love, care and positive intent. 

Colour variation may differ  then what screen monitors display. 

Please note there may be minor imperfections on the surfaces, due to the hand made nature of working with resin, and they are not machine made, or mass produced.  Minor imperfections does not affect the energy in any way.